1·The frequency of THG thrust force was analyzed.
分析了推力的频谱，发现推力存在着较大的波动。
2·The thrust force of an airplane is produced by the propeller.
飞机的推力由螺旋桨所产生。
3·However, additional equipments are needed to monitor the thrust force.
然而，更多的设备需要监测的推力。
4·The thrust force is mainly due to the drag of the wings in the upstroke.
平衡身体阻力的推力主要由翅膀上拍中产生的阻力提供。
5·However, the calculating precision of imbalance thrust force method is needed to discuss.
然而不平衡推力法的计算精度却有待进一步的探讨。
6·From the model, the effects of the dip Angle and feed rate on thrust force are estimated.
在此基础上，分析比较了进给量、斜面倾角等参数对斜面钻孔初期受力的影响。
7·Moreover, a gear pair with curvilinear - tooth traces operates without axial thrust force.
除此之外，具有曲线型齿线之齿轮在运转时亦不会产生轴向的推力。
8·Direct thrust force control method for the linear motor in theory and experiment has been further studied.
对适合直线电机直接推力控制的方法进行理论分析和实验研究。
9·If I just look at the thrust force based on the air (yes, there are some assumptions and estimations here), I get.
如果我只观察空气推力(是的，其中包含一些假设和估计)，我得到。
10·A comparative study of the thrust force at initial stages of drilling on inclined surfaces was conducted through experiments.
本研究通过实验，比较了斜面上钻孔与平面上钻孔在加工初期切削力的差异，对斜面上钻孔加工初期的受力进行了理论分析。
1·However, the calculating precision of imbalance thrust force method is needed to discuss.
然而不平衡推力法的计算精度却有待进一步的探讨。
2·Particularly with Taper Roller Bearings sufficient support of bearing rings by the adjacent parts is required due to the generated internal thrust force components.
尤其是圆锥滚子轴承的轴承环的邻近部位足够的支持是必需的，由于所产生的内部推力组件。
3·The thrust force is mainly due to the drag of the wings in the upstroke.
平衡身体阻力的推力主要由翅膀上拍中产生的阻力提供。
4·Imbalance thrust force method (ITFM) is originally developed approach for slope stability analysis in China, which has been widely used in the field of landslide stability analysis.
不平衡推力法是我国独创的边坡稳定分析方法，在滑坡稳定分析和治理中得到广泛地应用。
5·The steel axle of this kind of pig can bend under greater thrust force, it is helpful to pass through elbow or the section of converting pipe, so it can avoid efficiently block accident.
该清管器的钢轴能在较大推力作用下发生弯曲变形，有利于通过弯头或变形管段，可有效避免堵卡事故的发生。